I want to change my development board, it is now on "desktop"

1

For some reason my development that is for Arduino became desktop development. I can even change the properties but I can’t save. Look at the figures below. I don’t know if my screen is too small for the squireline, but I can’t give the ok to change the development board to Arduino. My board calls TAQUIONICA - ESP WROVER KIT. Is there any shortcut key to say ok after choosing my card?

Tela1
Tela11366×768 174 KB

Tela2
Tela21366×768 161 KB

Tela4
Tela41366×768 159 KB

Thanks

2

There is an apply-button at the bottom of the Project Settings panel but it’s not seen on your screen with the given resolution and scaling. You can decrease the UI-scale percentage in Preferences or in your OS to see that button.

3

Thanks. It´s working now.

1 Like